Installation Instructions

GENERAL PG2 INSTALLATION

CUSTOMERS INSTALL AT THEIR OWN RISK. Spring Compressor required.

1.) Properly removing and de-burring any sharp edges is necessary for stable performance of the ProGuide2 Tune Kit. Be sure that the airgun piston and contact components are clean of dirt and swarf.

2.) At the first stage of installing into the airgun, ease the ProGuide2 gently into place, slowly sliding the Pro-Guide2 into compression tube and piston, be watchful of the entry of the Pro-Guide2's outer dampening sleeve when its entering the guns piston. FURTHER, assure the cocking arm is held up to allow the outer ProGuide2 sleeve to pass under the cocking shoe face.

3.) Reassemble Airgun into stock.

Warning! If at this point you find obstruction of movement is felt to complete installation, STOP Immediately, and back out the assembly and turn 90 to 180 degrees clock-wise and repeat procedure of install. If the install still has bind upon re-entry of piston you may want  to contact Vortek direct or an authorized install dealer found on Vorteks web-site.

HW95/R9 Install

Click below for a detailed break down and installation of the PG2 with pictures. Thank you Kieth Knobs.

http://www.airgunadvice.net/viewtopic.php?t=13786